-
Toyotomi ToyoStove Laser 60-AT Direct Vent Kerosene Heater
- 30000 Btu - Oil - Kerosone - Diesel - Direct Vent - Color Antique Black
Product ID • LASER60AT000
Overview
Toyotomi ToyoStove Laser Direct Vent Kerosene Heater - 30,000 BTU - Antique Finish Black - LASER 60-AT
With the Toyostove LaseR 60-AT with 30,000 Btu's - you get much more heat for the money than with other conventional oil-fired heating systems as they are much less expensive to purchase, install and operate. The cost to operate a Toyotomi LaseR 60-AT vented heating system is so economical that owners enjoy annual savings of up to 50% over conventional heating systems. A Toyotomi heater can pay for itself in just a few short years. Most conventional oil-fired heating systems only run at peak efficiency 20% of the time. That’s because they first have to reach the desired temperature, then they have to cool down, then continually repeat this same process—like stop-and-go heavy city traffic driving. Toyotomi’s LaseR 60-AT special stainless steel heat exchangers carry the highest efficiency code and run at peak efficiency 100% of the time—like smooth, steady highway driving.
Toyotomi heaters don’t lose heat through ducts, pipes and registers like conventional heating systems do. Remember, it’s not necessarily how much fuel costs; it’s how much fuel you use. (By the way, did you know that oil generates one-third more heat (BTU output) than natural gas or propane?) Also, conventional heating systems consume indoor heated air and exhaust this out the chimney, which causes a vacuum that is filled by attracting outdoor cold air to infiltrate into the house. Toyotomi direct vent heating systems use outdoor air for combustion by utilizing their unique "pipe-within-a-pipe" forced-flue venting technology warming the incoming outdoor combustion air by the warm outgoing exhausted air, and they are modulating, meaning they maintain the desired temperature by automatically changing burning settings between high, medium and low.
Due to Toyotomi factory regulations, we are not permitted to ship Toyotomi products to the following states: AK, WA, CA, OR, ID, MT, NV, AZ, UT, CO, NM, HI, WY.
Manuals & Docs
Technical Specs
ToyoStove Laser Direct Vent Kerosene Heater LASER 60-AT Techs and Specs
- Fuel Type
- ASTM D3699 K1 KEROSENE
- Fuel Type
- ASTM D396 NO.1 LOW SULFUR FUEL OIL
- Fuel Type
- ASTM D975 ULTRA LOW SULFUR HEATING OIL/ DIESEL
- Cabinet Color
- Antique Black
- Heating Efficiency
- 87%
- Heating Rating High
- 30,000 Btu
- Heating Rating Med
- 21,000 Btu
- Heating Rating Low
- 12,000 Btu
- Fuel Consumption High
- .230 gallons per hour
- Fuel Consumption Med
- .161 gallons per hour
- Fuel Consumption Low
- .095 gallons per hour
- Size Inches
- 30 width x 24 height x 19 Depth
- Flue Included
- Yes - 4 to 9 inch thick wall
- Max Elevation
- 3,000 Feet
- Max Length of Vent Pipe
- 10 feet with 3 bends or less
- Vent Pipe Hole Size
- 3 Inches Diameter
- Electrical Rating
- 120 Volts
- Tank
- Exterior
- Weight
- 77 Pounds
ToyoStove Laser Direct Vent Kerosene Heater LASER 60-AT Features
- Sealed, direct-vented system means no drafts, no chimney, no special duct work, or special construction
- Compact Size
- Contemporary Design
- Power Failure Recovery System
- 24 Hours a Day Automatic
- 4 Cycle Burner Mode
- Shut-Off Safety System
- Set Back Thermostat
- 24 Hours AM/PM Timer
- Cool Top Cabinet
- Display Room Temperature, Set Temperature and Error Code
- Automatic Ignitor Cleaning System
- Only 3 inch Hole in Wall Needed for Flue Pipe
- Whisper Quiet Operation
- Safe - cETL home and mobile home listed
- Easy to install and operate
Info & Links