|
|
Williams Ventless Propane Gas or Natural Gas Space Heater Infrared - 1096513
Williams Ventless Gas Heaters Infrared Series require no electricty with fuel excahnge system allows to convert from Propane to Natural Gas
|
Williams Gas Space Ventless Heater - Infrared Series - Gas - 1096513
Williams Ventless Gas Heaters - Infrared Series - 1096513
|
Williams Furnace Company Infrared Vent Free Gas Heater 1096513 is 10,000 Btu for Propane Gas and 12,000 Btu for
Natural Gas. You can watch the Infrared glow warm behind the metal grill, as up to 12,000 Btu's of heat warm the room.
The 1096513 features top mounted controls and a matchless pilot ignitor.
Because no electricity is required for use, you are assured of keeping warm even during a power outage.
The Fuel Exchange System allows you to convert from Propane to Natural gas or Natural Gas to
Propane Gas without a conversion kit.
Distributes heat evenly throughout your room. Provides direct radiant heat. Ceramic plaques behind the grille gives this
ventless heater its’ warm glow.
Check local codes and ordinances for permitted uses. Operating heater at elevations above 4,500 feet could result in
nuisance outages.
|
Williams Gas Ventless Heater Features Infrared - 1096513
- Gas Type - Propane Gas or Natural Gas
- Natural Gas Input Rating - 12,000 BTU
- Propane Gas Input Rating - 10,000 BTU
- Thermal Efficiency - 99.9%
- Thermostat - Yes
- Floor Standing Mounts - Optional
- Electricity - None Required
- "Matchless" Piezo igniter - Yes
- Safety Glass - No
- Weight - 19 lbs
- Size - (length x height x depth) 14 1/8"L x 19 1/8"H x 7 1/8"D
- Gas Connection - 1/2" NPT
- Recommended Minimum Clearance - 8" from side of wall, floor or carpeting
- Recommended Minimum Clearance - 36" from top of appliance to ceiling or other obstruction
- Recommended Minimum Clearance - 2" from top of surface of carpeting or other combustable material
- Oxygen depletion Sensor (ODS) monitors room oxygen levels for safe operation
Williams Furnace Company Infrared Vent Free Gas Heater must not be installaed in a confined space unless provisions
are provided for adequate combustion and ventilation air.
The National Fuel Gas Code, ANSI Z223.1 defines a confined space as a space whose volume is less than 50 cubic feet per
1,000 Btu of the aggregate input rating of all applicances installed in that space and an unconfined space of not less than
50 cubic feet per 1,000 Btu of the aggregate input rating of all applicances in that space. Rooms communicating directly
with the space in which the appliances are installed, through openings not furnished with doors, are considered a part of the
unconfined space.
Oh My! - If you have any questions about installation or what size you need - please refer to the Williams Furnace Company Infrared Vent Free Gas Heater
install manual. You will find a link below for this PDF.
|
|