|
|
Qmark QFG Fan Electric Wall Heater QFG2024T2M Buy Page
Qmark Marley 220 Volt / 240 Volt Electric Room and Electric Space Heaters with built-in Thermostat
|
QMark QFG 2024T2M / QFG2024T2M Electric Wall Heater
|
Qmark QFG2024T2M electric space heater is suitable for use in almost any room. Qmark QFG
Electric Wall Heaters are efficient and do not take up any floor space as they are installed
in the wall and use a wishper quiet fan to move air around the room.
Use single wall heaters in smaller rooms such as bedrooms and bathrooms. Use multiple
space heaters (controlled by a single thermostat) in larger rooms such as living rooms
and family rooms. Wattage should be determined through heat loss calculations.
|
- 220/240 Volts
- 4 Wattage Setting
- 500 Watts - 2.1 Amps
- 1000 Watts - 4.2 Amps
- 1500 Watts - 6.3 Amps
- 2000 Watts - 8.3 Amps
- Dual Protection: Thermal cutout with indicator light and one time thermal fuse
- Tangential blower for whisper quiet operation
- Open coil element assures quick heat and low maintenance
- White baked enamel finish
- Hard wired
- Open coil element assures quick heat and low maintenance
- Three piece construction for ease of installation
- Permanently lubricated, dust protected bearings
- Wall Can Size: width 14-3/8" x height 6-5/8" x 4 3/8" depth
- Grill Size: width 16-7/8" x height 7-3/4" x depth 3/4"
- Built-In Thermostat
CLIP-N-FIT® FEATURE
Patented Clip-N-Fit® feature (US Patented No.
6,172,343) allows the installer to change the wattage of the heater to a lower
output without moving jumper wire. Each QFG electric wall heater is factory wired for its maximum
wattage. To change wattage, clip out either jumper 1 or 2 as shown in the
installation manual for desired wattage. This patented Clip-N-Fit® feature
also prevents the operator to change wattage after installation to a higher wattage.
What Size QFG2024T2M Electric Space Heater do you need? (Click Here)
|
|