Legend Versa Therm PEX Snap Fit Floor System
|
The Legend VersaTherm Floor System is an innovative, low-profile, high-output, snap-fit
pex radiant panel system ideally suited for both new construction and renovation projects.
Unlike any dry radiant system on the market, the panels snap together in minutes, saving
significant labor costs. The 3/4 inch thick panels are pre-insulated and naturally water
resistant- great for retrofits and basements. Our VersaTherm use of 1/2 inch PEX tubing allows
for greater circuit lengths. The tubing is 100% protected by metal and the entire surface
transfers heat. You can cut the main panels to size and use our optional fillers for non-active
space or use standard 3/4" plywood.
|
Legend VersaTherm Floor System Information:
- Labor Saving snaps together
- Installed over existing Floor
- Installed over existing Cement Floor
- 1/2 inch PEX tubing for longer circuit lengths
- PEX Tubing is protected against damage
- Panels are pre-insulated great for retrofits and basements
- Naturally water resistant
- Entire surface transfer sheat
- Panels are easily cut for tight installations
- PEX Tube spacing is 8 inches on center
Legend VersaTherm Floor System Specs:
- Main Panels ship with Tubes
- Main Panels Size - 31 1/2" by 15 3/4" by 3/4"
- Main Panels Square Feet - 3.44
- Return Panels Size - 15 3/4" by 15 3/4" by 3/4"
- Return Panel Heat Transfer Plates - Optional
- Filler Panel - Small and Large - Optional
|
|
Legend Versa Therm System Installed over a Slab - Click to see larger picture
|
Typical Basement Installation:
1) Carpet & Pad – VersaTherm panels “float” un-attached over top of the existing
concrete slab and vapor barrier; tack strips for carpet are installed on plywood filler
around perimeter of room between VersaTherm panels and wall; carpet and pad are
installed as normal on top of the VersaTherm panel layer.
2) Floating Floor Systems (engineered wood laminates) – VersaTherm panels
"float" un-attached over top of the existing concrete slab and vapor barrier; the
floating floor panels are installed as normal on top of the VersaTherm panel layer.
|
|
Legend Versa Therm System Installed over a Floor with Joists - Click to see larger picture
|
Typical Over Floor Installation:
1) Carpet & Pad – VersaTherm panels "float" un-attached over the top of the wood
sub-floor; tack strips for carpet are installed on plywood filler around perimeter of
room between VersaTherm panels and wall; carpet and pad are installed as normal
on top of the VersaTherm panel layer.
2) Hardwood – VersaTherm panels are "sandwiched" between the wood sub-floor
and wood nailing surface (typical ¾" plywood); 2" screws fasten wood nailing surface
down through VersaTherm panels into wood sub-floor; hardwood floor covering is
installed as normal on top of the wood nailing surface.
3) Ceramic Tile - VersaTherm panels are "sandwiched" between the wood sub-floor and
cement board (typical ¾" thick); 2" screws fasten cement board down through VersaTherm
panels into wood sub-floor (mark and avoid tubing locations); ceramic tile floor covering
is installed as normal on top of the cement board and isolation membrane.
|
|
|
Legend Versa Therm System Snaps Together
