|
|
Peter Mangone, Inc. Pneumatic Clip Gun Model RB-6
|
Utilizes both styles of clips - either RB Stand-Off and RB Flush Mount
Clips can be applied for radiant heating and potable water installations.
Lightweight and portable
Stand Off RB Clips
|
The RB-6 Pneumatic Clip Gun installs RB Clips quickly and perfectly. For above floor or under floor applications
in radiant floor heating, or in potable water pipe installations, the clip gun shoots safe, strong polyethylene
clips that fit perfectly without compressing or damaging the tubing or pipe
The "hammer head" of the pneumatic tool repeatedly strikes the two nails of the RB Clip until they are
driven 5/8" into the wood. The RB-6 Pneumatic Clip Gun is designed to install clips perfectly, with
no chance of overdriving the nails or piercing the tubing. The installation will be fast, strong, and
long-lasting, providing holding power that absolutely cannot pierce or damage the tubing or pipe.
Unlike other pneumatic tools, the RB-6 is lightweight and easy to use. This makes it especially comfortable
to use overhead, such as in "staple up" radiant heating installations. Also, a quick connect fitting is included
with the gun and an air plug is preattached, making set-up easier.
After attaching the air hose, load in a strip of clips and align the tool over the tubing so that it rests
directly onto the wooden surface. Smoothly and completely depress the handle allowing the head
of the tool to repeatedly strike the nails until the clip is fully seated. The RB-6 Pneumatic Clip Gun
will not permit the nails to be overdriven.
|
The RB6 Gun uses these Clips:
RB Stand-off Clips - Click Here
RB Flush Mount Clips - Click Here
|
Attaching Clips to the Floor
|
|
Attaching Clips under the Floor
|
|
