|
|
Heat-Timer ZCP Zone Controller - 926577-00
Set Point Controls, Hot Water Boiler Reset Controls and Pump Speed Controls
|
Heat-Timer ZCP Zone Controller - 926577-00
Heat-Timer ZCP Zone Controller - 926577-00
|
The Heat Timer Five-Zone Control that can operate either Zone Pumps or Zone Valves. One Zone Control to Stock.
The same control can be configured to operate either Zone Pumps or Zone Valves with End Switches. Just select the
proper output.
Domestic Hot Water Zone. The first Zone can be configured either as a heating zone or a Domestic Hot Water (DHW) zone.
The DHW Zone can then be configured to either have priority or to run without priority. When Priority is selected, An
adjustable Priority Time Delay is provided for better control.
Secondary Hard to Heat Priority Zone. Even with DHW Priority set, the ZCP can configure a zone to be excluded from the priority. This can be helpful for hard to heat zones. The ZCP will provide heat to those zones even during DHW priority calls.
|
Heat-Timer ZCP Zone Controller - 926577-00 Specifications:
- Zone Operation Modes - Zone Valve or Zone Pump
- Voltage Input - 120 VAC 60 Hz
- Power Consumption - 15 VA Max
- System Pump and Boiler Outputs - 2 N.O. S.P.S.T
- Zone Outputs - 5 Zones (Sourcing Power)
- Zone Power - Either 24VAC or 120VAC depending on the input to the Source terminals
- Zone Pump Output Relay Ratings - 1/8 HP, 120 VAC 60 Hz
- Zone Valve Output Relay Ratings - 24VA (1 Amp, 24 VAC 60 Hz)
- Control Operating Mode - Master or Slave
- Size - 3 1/2" by 13 1/4" by x 8 3/4"
- Weight - 2 pounds
- ZCP Communication Cable - Optional
Heat-Timer ZCP Zone Controller - 926577-00 Features:
- The ZCP has five built-in zone outputs in addition to boiler and system pump outputs
- The ZCP has Domestic Hot Water (DHW) Priority
- Ease of zone output wiring. Connect you zone outputs power source to one location on the ZCP. The ZCP will then power the zone pumps or zone valves
- Ease of thermostat input wiring. If your thermostat requires 24vac powering, just connect the transformer to the ZCP 24VAc input. The ZCP will then provide power to the thermostat inputs
- Add additional zones using another ZCP. Up to two ZCPs can be daisy chained for a total of 10 zone control
- Remote Enable/Disable (On/Off). Configure the On/Off input terminals to act as a thermostat call or connect it to a an outdoor reset control like the HWE-SS
|
|