|
Takagi TM-RE10
|
Temperature Remote Controller. The output temperature of the Takagi T-K3 can be controlled
with a TM-RE10 remote controller. It allows output temperatures beyond the factory settings and
shows error codes. The TM-RE10 also monitors incoming and outgoing water temperatures.
The temperature controller can adjust the output temperature from 99°F to 185°F.
Click here to purchase the TK-RE10
|
|
Takagi TK-TV01
|
The TK-TV01 wall vent terminator for installation of Takagi water heaters to be vented out a
side wall. Connect the Category III stainless steel vent pipe from the top of the unit
to the backside of this terminator to exhaust flue gases through the wall without
a thimble.
Click here to purchase the TK-TV01
|
|
Takagi TK-BF01
|
The TK-BF01 Vent Damper prevents the backflow of air through the exhaust vent. This
helps prevent harmful exhaust gases from entering the home, as well as helping to prevent
the unit from freezing in areas where cold air can be blown or drawn into the exhaust
system.
Click here for a TK-BF01 venting example
Click here to purchase the TK-BF01
|
|
Takagi TK-TV04
|
The TK-TV04 Vent Cap is for outdoor installation of the Takagi T-K3 tankless water heater.
The cap is installed on the top of the unit, instead of connecting an exhaust vent pipe.
The cap will prevent any debris that might be in the environment from entering the unit
and causing damage or a fire hazard, as well as preventing rain or other weather
from entering the unit.
Click here to purchase the TK-TV04
|
|
Takagi TK-TV10
|
The TK-TV10 Direct Venting Kit can be used to convert the Takagi T-K3 from a conventional vent
system to a direct vent (or sealed combustion) system. This is a CSA tested conversion kit.
Install this conversion kit in accordance with Takagi's installation
instructions and any applicable codes.
Click here to purchase the TK-TV10
|
|
Takagi TK-TV13
|
This is the Vent Terminator for the Takagi T-K3. Wall vent terminator for installation
to be vented out a side wall.
Vent Terminator dimensions: 13 3/4 inches wide by 12 inches high by 12 inches deep.
Click here to purchase the TK-TV13
|
|
Z-Flex Venting
|
Z Flex Stainless Steel Venting Accessories with silicone free connections. See
our full line of pipe, exterior terminators, elbows and more. Perfect for vertical
or horizontal installation. Stainless Steel Venting is required for all Takagi
Water Heaters (Exhaust Only).
Click here to see sizes and prices for ZFlex Venting Supplies
|
