HeatLink EasyFit Plumbing PEX Manifolds & Accessories
Heatlink Easyfit Pex Manifolds come in 2 and 3 Port Tees and are sold with 1/2 inch PEX adapters. So just order the actual amount of ports you need and you should be good to go. There are several different End Connection you need to choose from as well as 3/4 inch Tee to allow you to send hot or cold water to a separte plumbing manifold in a different location. If you want to use this manifold with 3/8 Inch PEX tubing - buy our Coupler 1/2 by 3/8 inch for each branch you want to use with 3/8 Inch PEX.
Use silicone lubricant to lubricate dry o-rings to ensure a tight seal. In case a leak develops during testing, remove pressure from system, clean the o-ring, and reapply silicon lube.
When placing the manifold into the supporting bracket, place the bottom snap-in lock in the bottom (braced) notch in bracket and then rotate it so that the top snaps into place. In order to prevent stress on the manifold supply end connections, the supply piping must be braced or supported, parallel to the manifold and centred with the manifold’s inlets.