|
|
Flow-Aide System Descaler
Safely removes scale, lime and rust from Tankless Water Heaters, Hydronic Boilers, Tank Water Heaters and more
|
Flow-Aide System Descaler
|
Scale, lime and rust buildup decreases the efficiency of tankless water heaters and other
appliances. Buildup can restrict flow and ultimately shut down a unit. Flow-Aide System Descaler
quickly dissolves water scale, lime, rust, and other water formed deposits, restoring efficiency
to most all appliances. Flow-Aide System Descaler is a non-acid, non-toxic concentrate which
is certified to NSF/ANSI 60 for use as a cleaner in potable water systems.
Flow-Aide System Descaler Uses:
- Tankless Water Heaters
- Hydronic Boilers
- Heat Exchangers
- Ice Machines
- Humidifiers
- Chillers
- Vacuum Pumps
- Condensers
- Evaporators
- Water Tanks
- Potable Waterlines
- Water Operated Equipment
Flow Aide System Descaler Features:
- Non-Corrosive
- Non-Toxic
- Fully Biodegradable *
- Safe to Handle
- Zero V.O.C.
* Flow-Aide is biodegradable with a BOD value of 16 mg/l. This normally allows the product to be water
flushed down sewers. Check with local ordinances and regulations in your area prior to disposal.
Flow Aide System Descaler Kit
Flow-Aide System Descaler
|
Flow-Aide System Descaler Kit Contains:
- 1 - 3.5 Gallon Bucket
- 1 - 350 GPH Pump
- 2 - 5 Foot Rubber Hoses
- 1 - Quart Flow-Aide
Whitlam Flow-Aide System Descaler Kit has been designed to work in
conjunction with isolation valves that provide 3/4" hot and cold service
connections. If these valves have not been installed on your heater, then the
heater must be disconnected from the plumbing and drained, and the Whitlam
Flow-Aide System Descaler Kit must be connected directly to the cold and hot
water connections. Whitlam Flow-Aide System Descaler is NSF approved and
safe to dispose of in drains*.
Flow-Aide System Descaling Procedure:
- Disconnect power to water heater.
- Close hot and cold isolation and service valves and remove service caps.
- Pour 1 gallon of water into bucket and place under water heater.
- Connect one hose to pump, and other end of same hose to cold service
valve. Place pump in bucket.
- Add contents of 1 quart bottle of Whitlam Flow-Aide to bucket (Liquid
should just cover pump housing). Additional Flow-Aide may be necessary
in larger or heavily scaled systems.
- Connect second hose to hot service valve. Place other end in bucket.
- Open both hot and cold service valves.
- Plug pump into grounded receptacle. Never allow pump to run without
adequate liquid in bucket or damage to the pump will occur.
- Allow pump to circulate Whitlam Flow-Aide solution through heater for
30-45 minutes. Unplug pump.
- Close cold service valve. Remove hose from cold service valve, and
replace service cap.
- Disconnect the hose from the pump and remove pump from bucket. Discard
Whitlam Flow-Aide solution*.
- Flush tankless water heater for 3-5 minutes or until water flows clear by
opening the cold isolation valve and allowing water to exit through the hot
service valve into a drain (connect two hoses if necessary) or drain into a
bucket. If using a bucket, empty periodically.
- Close hot service valve. Remove hose from service valve and replace
service cap; then open hot isolation valve.
- Connect power to water heater and return appliance to service.
|
|
Whitlam Flow-Aide PDF Documents
Related Items:
Webstone Isolator EXP Union Connectors
|
