Fantech Heat Recovery Ventilator Wall Controls
|
Fantech EDF1 - Triple Function Wall Control
It's easy to control your home's indoor air quality system with this triple function wall
control.
- Press the button once to run your HRV/ERV at a continuous low speed (Green).
- Press the button twice and the unit will run 20 Minutes On/40 Minutes Off (Yellow). The cycle repeats continuously.
- Push the button three times and the system will run continuously on high speed (Red).
|
|
Fantech EDF5 - Five Function Wall Control
Control multiple functions of your Fantech HRV/ERV with one slimline wall control.
Two-wire connection simplifies installation. Use one EDF5 per HRV/ERV installed.
- 30 - 90% RH Sensor
- Low, Medium & High Speed Selection
- 15, 30, 60 Minute Override
- Cycles Per Hour Selection
- Recirculation Control
|
|
Fantech MDEH1 - Dehumidistat Bath and Kitchen Control
Ideal for use in energy efficient houses where indoor humidity (during the heating season)
is higher than outdoor levels. High humidity is a major cause of structure damage and IAQ problems
such as mold and mildew.
- The MDEH1 is a rotary dial control without lights
- Just turn dial to set desired humidity level
- Multiple units can be used
- Install in bathrooms, kitchen, laundry
- Adjusts from 30-80% RH
|
|
Fantech RTS2 - 15-minute timer with LED Light
15-minute timer with LED light for use with Fantech Heat Recovery and Energy Recovery Ventilators.
- Works as an override switch to turn HRV or ERV on high speed for 15 minutes
- Up to five timers can be used
- Install in bathrooms, kitchen or laundry – where ever easy-access wall control is needed
|
|
Fantech RTS3 - Intermittent Timer LED Lights
Intermittent Timer with LED lights for use with Fantech Heat Recovery and Energy Recovery Ventilators.
The ideal control for those areas of the home where excess moisture, steam and odors are created.
- Press the button once to energize your HRV/ERV system to high speed for 20 Minutes (Green)
- Press the button twice and the unit will run for 40 Minutes at high speed (Yellow)
- Press the button three times and the unit kicks to high speed for 60 minutes (Red)
- When time expires the unit will return to its original setting
|
|
Fantech FH 20 (J10 810) Dehumidistat
Fantech Wall mounted dehumidistat.
- Adjustable between 20% and 80% relative humidity
- Switch suitable for up to 115 volt supply - Single Pole
- 7.5 amp rating
|
|
Fantech VT20M - Main Control
Fantech VT20M
|
- Infinite Speed control - fans can run at any speed (0% to 100%)
- Programmable Timmer - run time adjustable from 0 to 60 minutes
- High Speed 20 minute boost via touch pad
- 120 volts - max 2.5 amps
|
|
Fantech VT20A - Auxiliary Control
Fantech VT20A
|
- Touch pad on Auxillary Control is pressed, a blue light illuminates and fan runs at high speed for 20 minutes.
- Use up to three Auxillary Controls with one Main Control
|
Fantech Heat Recovery Ventilator PDF Manuals and Brochures - Click Here
|
